The reason for the smoke is incorrect wiring, posible melted insulation between motor windings and motor frame.
You mentioned connecting power to the red & and black wire. Did you do anything with White wire? Per the lable on the motor the black wire is high the Red is low. White common...
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Last edited by cwmagee; Yesterday, 08:44 PM.😀 1 -
The fact that you only had approximately 6 hours on the saw tells me there was a thin oily film on the clamps from the manufacturing process.
If problem continues you may have spread the clamps in the process of tighten blades. A common problem with OEM parts. This issue will disappear by replacing...👍 1Leave a comment:
-
I have had my Bosch Miter Saw since early 2000 and have used them three or four times at the most, That said is this new or is used? I am almost certain that they are available from replacementparts.com unless the saw model has been discontinuedLeave a comment:
-
-
-
Today 8/29/2023 during our tour of duty at the state fair, I got to do some demo cutting on Barbara's Seneca Falls Manufacturing "Challenge" scrollsaw. At first It was a bit of a challange to concentrate on keeping the feet rocking, blowing the dust away from the line as well as cutting out...👍 2Leave a comment:
No activity results to display
Show More
Leave a comment: