No announcement yet.

User Profile


Profile Sidebar

Profile Picture
uncle dean
experienced wood butcher
Last Activity: 03-10-2019, 11:48 AM
Joined: 10-08-2010
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • uncle dean
    replied to up stop for excalibur ex19
    The trunion (inside the back end of the upper arm) is not intended to rotate. it binds the adjuster t-bolt to hold the upper arm in a raised position. The trunion must be fixed to the upper arm.

    I drilled into the joint between end of trunion and side of upper...
    See more | Go to post
    Last edited by uncle dean; 03-10-2019, 11:46 AM.

    Leave a comment:

  • uncle dean
    started a topic up stop for excalibur ex19

    up stop for excalibur ex19

    I just finished replacing all the bearings in my Excalibur EX19VS and it runs smooth as glass,,, but,,,the upper arm will not stay up like it did before. I suspect something in the (rear) tension rod is not correct. My owners manual shows a coil spring below the Cross Trunnion, but my machine did not...
    See more | Go to post
No activity results to display
Show More