Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
If you are referring to 3D Compound cutting, the blade is 90 degrees to the table and not tilted. I use the tilting head for things like inlays and Carole's bowls. If you want a tilting arm, be sure it is rack and pinion. Look at other features that may fit your needs. As a Pegas dealer, I can help...
- Likes 1
-
Teach - Learn
A modified Sue Mey pattern to fit 1" x 4" x 10" Hard Maple. Cut on the Pegas scroll saw using a Pegas #5 MGT blade. One side says "TEACH". Flip it over and the other side says "LEARN". After sanding, dipped in diluted Shellac, sanded again and another dipping. Comments...You do not have permission to view this gallery.
This gallery has 2 photos.
- Likes 1
-
Very well done, especially for your first. I too like the added detail.
Leave a comment:
-
-
-
Thanks Scott. I try to finish most of my projects, but there are a few still sitting around....
Leave a comment:
-
Betty, I enlarged the pattern by 30% to fit on 10" square stock....
Leave a comment:
-
Alex Fox Basket C12
An Alex Fox pattern he lists as C12. I used 1/4" Baltic Birch plywood 10" square. Cut on the Pegas scroll saw using Pegas #1 MGT blades. After gluing, two coats of spray Lacquer clear gloss. Comments welcome....
- Likes 2
-
-
Thanks Rolf. This one stands about 6 1/2" high. Shrinking it would make it fun to make....
Leave a comment:
-
-
Valentine Gnomes
Valentine Gnomes is a Steve Good pattern. I used 1/4" Baltic Birch plywood approximately 12" square. Cut on the Pegas Scroll Saw using Pegas #1 blades. I stained the heart with Samen stain Raspberry. Dipped in diluted Shellac, sanded and then one coat with spray Lacquer clear satin. Comments...You do not have permission to view this gallery.
This gallery has 1 photos.
- Likes 6
-
Thanks Pete. BTW, the #2/0 and #1 MGT in the dozen packs are in stock....
Leave a comment:
-
Two Non-Puzzles Horse and Rescue Standing
Two non-puzzles finished. Patterns by Harvy Blyer. I used 3/4" Poplar approximately 8" square. Cut on the Pegas scroll saw using Pegas #3 MGT and #5 MGT for the veining. After sanding, dipped in diluted Shellac. Comments welcomeYou do not have permission to view this gallery.
This gallery has 2 photos.
- Likes 3
-
Welcome to the forum from Tennessee.. The workbook is a great place to start.
Leave a comment:
-
-
Thanks Pete. Yes, they sell very well, in fact, these already sold....
Leave a comment:
-
I use a #6 Super Skip for the birdhouses. There are no reverse teeth and in compound cutting you don't need reverse teeth. Reverse teeth tend to clog the kerf. The #6 is .0150" thick x .044" wide x 12.0 tpi....
Leave a comment:
-
I use blue painters tape applied directly to the wood, then apply the label. Removes with ease....
- Likes 1
Leave a comment:
No activity results to display
Show More
Leave a comment: