I have been working on this project for some time & finally got this far with it. Need to make the frames for them now. Have some ideas for a frame design, but, not sure yet. I used 1/4 in. oak & stack cut them for a first time stack cut. I had some problems with the ply warping, but, will be able to correct that when I frame them. Any comments are welcome. Thanks
Announcement
Collapse
No announcement yet.
Iwo Jima::::
Collapse
X
-
That is quite the undertaking. Nicely done."Still Montana Mike"
"Don't worry about old age--it doesn't last that long."
Mike's Wood-n-Things LLC
-
Comment
-
Thank you for your kind words. I aggree with the drilling, Larry, it is really a pain, since I had to drill all the center ones with a hand drill. My drill press would not reach that far. I think there were more than the ones I drilled with the press. Anyway, it was a long time venture & I really enjoyed doing it. Now for the frames. Thanks again.PERK
Comment
-
Looks good. I am cutting the same patteren, I cut alittle and move to another project for awhile and go back to it for some more cuts.
Will
Comment
Unconfigured Ad Widget
Collapse
Latest Topics
Collapse
-
Reply to FInished Productby tgiro01It will sit on the coffee table for a couple of weeks/months - Until I finish the next one. Then it get relegated to the collection to await the next craft show. Or it may go to the art gallery for a few months.
Jim - Same two words I gave Rolf and Scott -- Wedgie Sled. Jerry Bennett's...-
Channel: Off Topic
Yesterday, 07:16 PM -
Comment