Announcement

Collapse
No announcement yet.

A gift for my new grandaughter I made

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • A gift for my new grandaughter I made

    I made this for my new granddaughter born just recently. I wanted something she could always keep to remember me by when I am gone someday
    Bill

    DEWALT 788 and Hegner 18vs..... AND STILL CUTTIN IT UP!!!!


    Member of Scrollsaw Association of the World

  • #2
    Very nicely done Bill !
    Frieke
    www.friewoodart.webs.com

    Visit Frieke's gallery

    Don't let the pain of your past and the fear of your future ruin the happiness of your present.

    Comment


    • #3
      Lovely - she will treasure it.
      DeWalt 788

      Comment


      • #4
        Nicely done.
        "Still Montana Mike"

        "Don't worry about old age--it doesn't last that long."
        Mike's Wood-n-Things LLC

        Comment


        • #5
          Nice work Bill .........................MB
          Usually busier than a cat in a sandbox !!!!!!!!!!! MB { Dewalt 788 only }

          Comment

          Unconfigured Ad Widget

          Collapse

          Latest Topics

          Collapse

          • axor
            Reply to Shawl pins
            by axor

            Yes, they can be used for hair. If they are made a little larger than the original, the shawl pins will work great in the hair!...
            Today, 03:21 PM
          • handibunny
            Reply to EX dust collection holes screwed up a project.!
            by handibunny
            Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
            Today, 09:21 AM
          • Bill Wilson
            Reply to EX dust collection holes screwed up a project.!
            by Bill Wilson
            I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
            Today, 09:06 AM
          • cwmagee
            Reply to EX dust collection holes screwed up a project.!
            by cwmagee
            Carole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
            Today, 08:40 AM
          • Rolf
            Reply to EX dust collection holes screwed up a project.!
            by Rolf
            That is an interesting point Carole. I have done some bevel cutting on the EX and can't say that I have experienced an increase in vibration or any problems with following the lines. I know when I cut one of your bowl designs on my Hawk I really had to concentrate on not pushing down hill....
            Today, 07:28 AM
          Working...
          X