Announcement

Collapse
No announcement yet.

a coffee table

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • a coffee table

    I am making this coffee table for my son for Christmas. I have touch it up and put the bar top resin on and the legs it is 5ft long. it is the whit ponderosa pine on the bottom and the elk is 1/8 inch oak plywood
    Attached Files

  • #2
    Looking good from here .........
    Usually busier than a cat in a sandbox !!!!!!!!!!! MB { Dewalt 788 only }

    Comment


    • #3
      This is a great gift for your son! I hope you remember to post a photo after you use the bar-top resin, as I'd love to see how that comes out! I'm assuming it will go over the entire top?

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • will8989
        Rolf,
        by will8989
        Are you ok Rolf?
        Today, 05:43 PM
      • Jim McDonald
        Reply to About ornament exchange
        by Jim McDonald
        Dave, I will participate. Thanks for doing this again.
        Today, 09:10 AM
      • Rolf
        Reply to Testing this blower motor
        by Rolf
        Without the complete schematic it is hard to know what is correct.
        That said, it is a multispeed blower that obviously has a controller board. That board varies the power to the motor. By doing what you did you bypassed that. You put power across the low and high windings. If any thing connecting...
        Today, 07:43 AM
      • evilbadger
        Reply to Testing this blower motor
        by evilbadger
        If he connected to red and black and the motor spun wouldn't that indicate the motor is grounded? Without connecting the white the circuit isn't complete and the motor should not spin.
        Today, 06:40 AM
      • cwmagee
        Reply to Testing this blower motor
        by cwmagee
        The reason for the smoke is incorrect wiring, posible melted insulation between motor windings and motor frame.

        You mentioned connecting power to the red & and black wire. Did you do anything with White wire? Per the lable on the motor the black wire is high the Red is low. White common...
        Yesterday, 08:41 PM
      Working...
      X
      😀
      🥰
      🤢
      😎
      😡
      👍
      👎