If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I love it Fred!! I have seen this on the Toys and Joys site and really wanted to try it. Was it very difficult?? Welcome to the forum and thanks for sharing. Look forward to seeing more of your work.
Cathy in NE
"While we try to teach our children all about life, our children teach us what life is all about." - Anonymous
Rolf
RBI G4 26 Hawk, EX 16 with Pegas clamps, Nova 1624 DVR XP
Philosophy "I don't know that I can't, therefore I can"
Proud Member of the Long Island Woodworkers Club
And the Long Island Scrollsaw Association
Right now I live in the greater Houston area, which is by Texas standards 'next door', meaning you only have to drive 4 hours, 2 of them being the Houston commute. But yea, I miss the old missions. That's why I made this project.
I have both types of saw A tilting table Hawk g426 and an Older Excalibur with a tilting head. Unlike Carole for bevel cuts I prefer the tilting head I do larger projects and it is easier for me.
Regarding compound cuts they are cut at 90 degrees.
If you have a good saw, and can set the table accurately, you should be good to go. Give a holler if you need help. 😁
Randy, I swapped out the clamps on the Jet for the Pegas clamps as soon as they became available. I found the Jet clamps just too fidgety for my taste.
Comment