Announcement

Collapse
No announcement yet.

Reposting, Need an assist here

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Reposting, Need an assist here

    I am reposting this in this thread in hopes that some of you finishing gurus may be able to help Jim. He is just getting aquianted with our forum...Jim I hope you don't mind that I did this, I just wanted it to be in the right area where it will be more visable to those who can offer you assistance.



    See posting " TUNG OIL AND SANDING BELTS"

    I posted about Tung Oil, and how to remove the smell of the oil.

    Any help would be appreciated.

    Thanks
    Jim form Ontario
    Todd

    Hawk G4, Dremel 1800

    Quando Omni Flunkus Moritati

  • #2
    Reply about !00% Tung Oil

    I answered the question on that post.

    I hope it helps.

    Mac

    Comment


    • #3
      Thanks for handling that Mac, I was worried that his question would get lost in the wrong thread where someone like yourself may not have seen it.
      Todd

      Hawk G4, Dremel 1800

      Quando Omni Flunkus Moritati

      Comment


      • #4
        Tung Oil

        Glad to help.

        Mac

        Comment

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse

        • will8989
          Reply to My beauties
          by will8989
          He puts biscuts between the long pieces, is that what you meant? He has stainless screws in the lips then puts the plugs on top of that. Scott, cutting one doesn’t take long. It’s the removing of the tiny drill hole, spraying each piece with distilled water, letting dry, sanding and sometimes flap...
          Today, 10:55 AM
        • Rolf
          Reply to Cutting guide for straight cut on a scroolsaw
          by Rolf
          Like Bob said clamp a straight edge to the table and adjust it to compensate for the blade drift. There are some blades that have no or very little drift. Like the Olson PGT series it also seems to me that the Pegas MGT 3 or larger cut very straight....
          Today, 07:54 AM
        • Rolf
          Reply to My beauties
          by Rolf
          I now you do beautiful work but I have to say your attention to details on these baskets is impressive. soft smooth edges, no visible glue squeeze out. And of course the cutting boards are beautiful. I am guessing that Bruce cut a spline in the end of the board and then dowels. I have not seen that...
          Today, 07:49 AM
        • NC Scroller
          Reply to My beauties
          by NC Scroller
          You are one busy lady. About how long does it take to cut one?
          Today, 05:51 AM
        • NC Scroller
          Reply to Hegner Multimax-18 for sale Tucson
          by NC Scroller
          Good luck.
          Today, 05:47 AM
        Working...
        X