If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
At the time I thought "Ah, spit!" (or words like that) and just threw the blade in the garbage. It was the #5 size blade. I suspect it would cost more to have it done than the cost of a new blade. The owners manual is not very helpful, the wording is awkward, having been 'translated' into...
The brazing process doesn't look too bad. I have seen the welders built into the industrial bandsaws, so out of curiosity, I looked that up and that process is pretty cool to watch also, though trying that on something this small would probably light the whole thing up....
Jo, I did a bit of research on the web, and there are lots of videos of people silver soldering broken blades. In hindsight I remember I had made a jig eons ago to do just that, when I still had a small Craftsman bench top three wheeler....
Tweet
Comment