Announcement
Collapse
No announcement yet.
100% pure Tung oil online
Collapse
X
-
100% pure Tung oil online
With the recent discussion on Tung oil in another thread I thought I'd offer these two sites that carry pure Tung oil online, I know I am unable to find it locally.
here is the 1st one complete with pricing http://www.rockler.com/product.cfm?page=6524
and the 2nd one also with pricing http://www.realmilkpaint.com/oil.html
For a faster dry time you can just add mineral spirits, a 50/50 mix works fine.
Ozarkhillbilly
BillTags: None
Unconfigured Ad Widget
Collapse
Latest Topics
Collapse
-
by RolfA family friends father passed away and he was an avid bird carver. So my nephew is helping the family sell some of his tools. I bought this air cleaner and will b uy most of his carving knives and burrs. And no that is not my workshop! Not even close. ...
-
Channel: Tools and Blades
Today, 04:47 PM -
-
by RolfI just did a quick job on my table. Charles Hand has noticed that the adhesive on the new rolls of Contact brand shelf paper leaves a residue. He has changed to The duck brand. I just bought a roll and covered my table with it. It is a tough slick surface. It will be interesting to see how it holds...
-
Channel: Tools and Blades
Today, 04:44 PM -
-
Reply to Shawl pinsby axor
Yes, they can be used for hair. If they are made a little larger than the original, the shawl pins will work great in the hair!...-
Channel: General Scroll Saw
Today, 03:21 PM -
-
by handibunnyRolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
-
Channel: Tools and Blades
Today, 09:21 AM -
-
by Bill WilsonI've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
-
Channel: Tools and Blades
Today, 09:06 AM -
Leave a comment: