Announcement

Collapse
No announcement yet.

help ordering wood

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • help ordering wood

    sup all, finished my second project and want to attempt intarsia. there is a free teddy bear pattern i found and want to give it a shot. The thing is i cannot find the 4 pieces of wood online in one website...

    3/4" black walnut
    3/4" Aromatic Cedar
    3/4" Pine
    3/4" Western Red Cedar

    Does anyone know of a website that carries these pieces. i've been on several that may have one or another but not all........appreciate your help....joe

  • #2
    I PMed you. Dale
    Dale w/ yella saws

    Comment


    • #3
      lucky, thanks...exactly what i was looking for...appreciate it....joe

      Comment


      • #4
        That's all standard wood available at Menards.
        Jeff Powell

        Comment


        • #5
          i dont have one in my area...thanks

          Comment


          • #6
            Joe,

            Don't be afraid to try other types of wood. I usually use the wood I have available with good outcome.

            Dan
            Dan H

            I would rather be friendly to a stranger than be a stranger to my friends.

            Comment

            Unconfigured Ad Widget

            Collapse

            Latest Topics

            Collapse

            • will8989
              Rolf,
              by will8989
              Are you ok Rolf?
              Yesterday, 05:43 PM
            • Jim McDonald
              Reply to About ornament exchange
              by Jim McDonald
              Dave, I will participate. Thanks for doing this again.
              Yesterday, 09:10 AM
            • Rolf
              Reply to Testing this blower motor
              by Rolf
              Without the complete schematic it is hard to know what is correct.
              That said, it is a multispeed blower that obviously has a controller board. That board varies the power to the motor. By doing what you did you bypassed that. You put power across the low and high windings. If any thing connecting...
              Yesterday, 07:43 AM
            • evilbadger
              Reply to Testing this blower motor
              by evilbadger
              If he connected to red and black and the motor spun wouldn't that indicate the motor is grounded? Without connecting the white the circuit isn't complete and the motor should not spin.
              Yesterday, 06:40 AM
            • cwmagee
              Reply to Testing this blower motor
              by cwmagee
              The reason for the smoke is incorrect wiring, posible melted insulation between motor windings and motor frame.

              You mentioned connecting power to the red & and black wire. Did you do anything with White wire? Per the lable on the motor the black wire is high the Red is low. White common...
              09-28-2023, 08:41 PM
            Working...
            X
            😀
            🥰
            🤢
            😎
            😡
            👍
            👎