If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Very nice! I really like your setup especially for the dust collection. I would have to figure out a way to re-weld the blade.
And Oh to have wall space and organizational skills!
Most of the cut outs were done with the scroll saw.
Karl I have a couple of power carvers. The classic Dremel with a flex shaft I then bought a Ram Power carver, they both use 1/8 shank bits. I have a bunch of carbide cutters from when our Printed circuit board facility at work was dismantled....
Tweet
