No announcement yet.

flap sander

  • Filter
  • Time
  • Show
Clear All
new posts

  • flap sander

    I posted a year or so ago, about making your own sanding mops, but this guy takes it to a new level --

    My Son-in-law said "Darnit, I cut this board twice, now. And it's still too short."

  • #2
    Very impressive what he did with such a minimal assortment of basic tools.
    RBI G4 Hawk, Delta SS350, Nova 1624 DVR XP
    Philosophy "I don't know that I can't, therefore I can"
    Proud Member of the Long Island Woodworkers Club
    And the Long Island Scrollsaw Association


    Unconfigured Ad Widget


    Latest Topics


    • will8989
      Advent wreath
      by will8989
      For one of my good customers. From the fall issue 2016. Cherry and African mahogany. Bruce turned the candle holders as we couldn’t find candles to fit any already made wooden holders. I used the green sparkle unicorn spit over green paint for holly leaves and red for the berries. Yes, I actually...
      Yesterday, 11:39 PM
    • Ennobee
      Reply to 10" long truck.
      by Ennobee
      Looks pretty neat. So it's from a 2x4: 3 in wide, 'bit less then 2 in. high? So how did you get the trunk cut out? You mentioned cutting the sides with a scroll saw, did you slice off two sides and then cut out the middle?...
      Yesterday, 09:46 PM
    • vgraf
      Reply to sanding sealer or shellac
      by vgraf
      I use sanding sealer on baltic birch plywood, pine and birch if I am going to stain them. Without the sanding sealer, the stain will be blotchy. I use the water base sealer from minwax. After it drys I sand to at least 150 grit and often to 220 grit. Wipe it with a tac cloth then apply the masking...
      Yesterday, 08:27 PM
    • Jim Finn
      Reply to 10" long truck.
      by Jim Finn
      We, our club, delivered over 900 toys last week to The Salvation Army, Ronald McDonald House, and a local children's hospital. Included were most of these trucks. (I sold a few)
      Yesterday, 07:17 PM
    • NC Scroller
      Reply to sanding sealer or shellac
      by NC Scroller
      The real nice thing about using shellac and alcohol mix for ornaments is you only have to wait minutes before you tie in your ribbons and packaging.
      Yesterday, 10:48 AM