No announcement yet.

Shout out to D & D

  • Filter
  • Time
  • Show
Clear All
new posts

  • Shout out to D & D

    Ordered some Pegas blades from D & D late on Monday afternoon. Had them in my hands on Thursday morning. Only way to get them faster would have required me to drive to PA.
    Creator of fine designer sawdust.

  • #2
    I buy my Pegas Modified Geometry blades from D&D also. Great service. And Pegas makes great blades. When I had trouble cutting 3/4" hardwood puzzles with Flying Dutchman blades I called D&D and they recommended the Modified Geometry blades. Best call I made. But I still use the Flying Dutchman puzzle blade for 1/4" Baltic Birch plywood. There is no equal in my opinion.
    Last edited by bbofpp; 06-19-2017, 08:35 AM.

    visit us at Pickens Puzzles:


    • #3
      I ordered from them on the 16th and see that they made it to my P.O. this morning. Cannot complain at the service.
      AKA Paul from Washington State
      Hegner Multimax 22-V and Seyco ST-21


      Unconfigured Ad Widget


      Latest Topics


      • Dan A
        Reply to compound cutting
        Dan A
        I'm pretty sure the blade was in right. It was an 1 3/4 piece of poplar. Once I was done cutting I couldn't even get the piece to come apart out of the block. Which as I remember it, indicates to much pushing and making the blade bend.

        For what it's worth I cut an ornament out of pine and...
        Today, 06:17 AM
      • leehljp
        Reply to Shingles
        My wife got the vaccine shot in 2011 and 4 months later came down with shingles. It wasn't a light case either.

        My aunt said she found a cure for shingles: She heard that rubbing Dr. Tichenors antiseptic on it would stop it. She got in the tub and poured some on. As she tells it: "When...
        Yesterday, 10:15 PM
      • vgraf
        Reply to Mass Production
        I also cannot perceive making that many of anything. I just finished about 30 of the mini birdhouses and am ready to start something new.

        I also have used the alcohol and shellac method. It really speeds up the finishing process. If the surface is left a little rough, a little touch up...
        Yesterday, 09:29 PM
      • vgraf
        Reply to compound cutting
        I had trouble cutting once with a new blade and then discovered I had it backwards.
        Yesterday, 09:23 PM
      • NC Scroller
        Reply to Fall magazine
        NC Scroller
        Can't wait to get mine.
        Yesterday, 08:51 PM