I got a new Delta P-20 scrollsaw last Dec and recently I had a
chance to test their warranty. The little spring broke on the spring
loaded cap on the oil cup on the upper arm pivot.
Also, I noticed a very slight hairline crack in the table casting
right close to the hole for the insert. It would never have caused
any problem in a million years and the table was dead flat from all
directions but because it was a manufacturing defect, I asked my
dealer about it. He said give me the model and serial numbers.
Today an oil cup assembly and a brand new table top arrived (prepaid
express post) and they don't even want the original one back. That
is a big heavy dead flat cast table. Now I'm trying to figure out
what use I will put the original one to.
W.Y.
chance to test their warranty. The little spring broke on the spring
loaded cap on the oil cup on the upper arm pivot.
Also, I noticed a very slight hairline crack in the table casting
right close to the hole for the insert. It would never have caused
any problem in a million years and the table was dead flat from all
directions but because it was a manufacturing defect, I asked my
dealer about it. He said give me the model and serial numbers.
Today an oil cup assembly and a brand new table top arrived (prepaid
express post) and they don't even want the original one back. That
is a big heavy dead flat cast table. Now I'm trying to figure out
what use I will put the original one to.
W.Y.
