No announcement yet.

Dremel scroll saw

  • Time
  • Show
Clear All
new posts

  • Dremel scroll saw

    I have a new Dremel scroll saw (less than 3 months old) and last night it broke. When i turn it on the arms just freeze. I am not a novice but this is a new saw, has anyone had this experience? Just want to know before I have to send it out for repairs, which leads me to question number two. Is Dremel the only authorized place for repairs?
    thank you,

  • #2
    Re: Dremel scroll saw

    No..our local repair shop is in tru value hardware..can't help you with the freeze up... ???


    Unconfigured Ad Widget


    Latest Topics


    • Rolf
      Reply to Arizona Animals Intarsia Collage Fair Results
      by Rolf
      Our Judges are some of the best woodworkers I have ever met. On occasion I get asked to explain what I look for in the scrolling categories. I point out all of the nuances. I can't be a judge as I have intarsia and scroll work entries.
      Today, 07:36 AM
    • Rolf
      Reply to Problem with thinner blades on Dewalt 788
      by Rolf
      There may have been some crud on the tips from manufacturing.
      In the ~20 years of scrolling I never cleaned the ends of my blades until recently. Even with the Pegas clamps I was having some blade slippage, I now scuff the ends of my blades with some 220 grit paper End of problem.!...
      Today, 07:29 AM
    • NC Scroller
      Reply to Problem with thinner blades on Dewalt 788
      by NC Scroller
      Don’t over sand them as you will shorten their usable life. Only sand as needed. Another thing to do is clear your blades before installing. Blades are coated with oil to prevent rust. Wipe the ends with alcohol or lightly sand with 320 grit.
      Today, 05:29 AM
    • cwmagee
      Reply to Problem with thinner blades on Dewalt 788
      by cwmagee
      The fact that you only had approximately 6 hours on the saw tells me there was a thin oily film on the clamps from the manufacturing process.
      If problem continues you may have spread the clamps in the process of tighten blades. A common problem with OEM parts. This issue will disappear by replacing...
      Yesterday, 08:46 PM
    • will8989
      Reply to Mitre saw material clamps
      by will8989
      10” compound dual bevel sliding mitre saw with laser. Bruce said to buy a new blade because the blade that comes with it sucks. Sells here for $289. It was on sale plus his military discount and a $50 gift certificate from his woodworking club. Bruce said to check out on Google 10” kolbalt mitre...
      Yesterday, 08:45 PM