Announcement

Collapse
No announcement yet.

Dewalt DW788 Table hole issue.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Dewalt DW788 Table hole issue.

    Has anyone figured out how to fixe the hole problem with the dw788? It was cut off center to the blade. I used some sanding strips on it yesturday and the strips actually cut the hole wider and left a ridge. I'm tempted to take my dremel to it, but I wanted to see if there was a real solution first.

    It's not actually a big problem, just an annoying one.
    John Patrick, Bird Oasis
    www.birdoasis.com
    Using Dewalt DW788. Working on a new line of birdhouses and bird feeders for the store.

    I welcome any and all ideas for bird friendly scrolling.

  • #2
    I don't really suggest you try this but my recent purchase of a refurbished type 2 I bought through Amazon all they seemed to have done to correct the off center hole was to bend the upper and lower arms to your left as your facing the saw I know its laughable but thats what the did
    Daryl S. Walters Psycotic scroller with a DeWalt 788

    Comment


    • #3
      Thats insane!!! I would demand a new table! Dont go bending nothing! Dale
      Dale w/ yella saws

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • Linda In Phoenix
        Reply to My computer issues.
        by Linda In Phoenix
        I upgraded back in early winter. I got one with both a solid state as well as hard drive. I couldn't move over my Office 2010 because I'd bought it as a download (which was still functioning just fine for what I used it for) and I never switched it to subscription because of the cost. The old download...
        Today, 12:39 PM
      • Rolf
        New turning tools
        by Rolf
        I just picked up a couple of new heavy handled bowl gauges. 1/2 inch and 3/8 inch from two friends that have tool supply businesses.
        Our next Scroll saw club challenge will be segmented scroll saw bowls. I don't sand my bowls, too time consuming, so I will be turning them after glue up.
        ...
        Today, 08:04 AM
      • Rolf
        Reply to My computer issues.
        by Rolf
        One problem with upgrading was that many of the programs I use are now subscription based. That really frosts my butt I finally accepted the fact that I normally renew my software frequently anyway the cost difference is negligible.

        I did not go with a solid state drive, probably...
        Today, 07:58 AM
      • will8989
        Reply to My computer issues.
        by will8989
        Actually, I think mine is more than 10 years old. And what brand would that be? Remember who you’re talking to here about computers.
        Today, 07:49 AM
      • NC Scroller
        Reply to My computer issues.
        by NC Scroller
        If you buy a new computer you want to get a solid state hard drive. No moving parts to break or wear out....
        Today, 07:43 AM
      Working...
      X