Announcement

Collapse
No announcement yet.

Dremel Model 1680/need PN help

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Dremel Model 1680/need PN help

    Hello everyone, I have this model Dremel scroll saw #1680. I looked at the parts diagram and called sears, and still can't figure out the PN I need. I am missing the "upper clamp knob". Also the screw that this clamp knob goes onto.
    I hope someone has the answer. If you do....you are my hero!

    No worries,
    Julie

  • #2
    Hi Julie,

    Give Dremel Customer Service a call. They have always been very helpful to me.

    Comment


    • #3
      You might chat with these folks, also -- Pozsgai's Designs - Scroll Saw

      They have some retrofit parts for Dremels. I didn't see your model listed, but sometimes, parts are interchangeable..
      The good woodworker does not craft the wood for honor. He uses his craft to honor the wood.

      Comment


      • #4
        julie

        call dremal customer service and they have parts i just recived the part you are looking for plus are to set tention if you have a problem the tech will help you out
        bob

        Comment


        • #5
          This might help:

          http://ec1.images-amazon.com/media/i...L000006023.pdf
          Scott
          Creator of fine designer sawdust.

          Comment

          Unconfigured Ad Widget

          Collapse

          Latest Topics

          Collapse

          • Daddy's scroller
            Reply to Frustrated
            by Daddy's scroller
            I have a craftsman saw. The blade just slips out.
            Yesterday, 07:00 PM
          • Daddy's scroller
            Reply to Frustrated
            by Daddy's scroller
            No. I haven't tried that yet...
            Yesterday, 06:55 PM
          • Chance13
            Reply to Frustrated
            by Chance13
            I put those on my 20" Dewalt a couple years ago. Big improvement from the one Dewalt had....
            Yesterday, 11:08 AM
          • Rolf
            Reply to Frustrated
            by Rolf
            We need to know what saw you are using, as they have different clamps.
            Yesterday, 07:59 AM
          • markdavd
            Reply to Frustrated
            by markdavd
            When a blade slips out, the tendency is to tighten it more. Make sure you haven't over-tightened the clamp forcing the sides apart. Most OEM clamps are made from soft aluminum so once it starts they will continue spreading and it will be near-impossible to keep the blades in place.

            I've...
            05-21-2022, 10:03 AM
          Working...
          X