No announcement yet.

Dremel Model 1680/need PN help

  • Filter
  • Time
  • Show
Clear All
new posts

  • Dremel Model 1680/need PN help

    Hello everyone, I have this model Dremel scroll saw #1680. I looked at the parts diagram and called sears, and still can't figure out the PN I need. I am missing the "upper clamp knob". Also the screw that this clamp knob goes onto.
    I hope someone has the answer. If you are my hero!

    No worries,

  • #2
    Hi Julie,

    Give Dremel Customer Service a call. They have always been very helpful to me.


    • #3
      You might chat with these folks, also -- Pozsgai's Designs - Scroll Saw

      They have some retrofit parts for Dremels. I didn't see your model listed, but sometimes, parts are interchangeable..
      The good woodworker does not craft the wood for honor. He uses his craft to honor the wood.


      • #4

        call dremal customer service and they have parts i just recived the part you are looking for plus are to set tention if you have a problem the tech will help you out


        • #5
          This might help:

          Creator of fine designer sawdust.


          Unconfigured Ad Widget


          Latest Topics


          • Gary beasley
            Reply to What do you think?
            by Gary beasley
            I tried a house vac once for a dust collector. It was prone to clogging the lines and when I tried to put a cyclone can on it the vacuum collapsed the garbage can.
            Yesterday, 09:29 PM
          • Gary beasley
            Reply to Vases
            by Gary beasley
            I found this pattern in Steves catalog and freehanded a vase form. This one may appeal to the folks that bought the butterfly vase.
            Yesterday, 09:25 PM
          • Trackman
            Reply to Vases
            by Trackman
            Sorry took so long to answer. The brown vase I added butterfly instead of doing wood burning. Wanted to keep them so they would appeal to several people. I sold all of them to a flower shop....
            Yesterday, 05:13 PM
          • Bill Wilson
            Reply to My lucky day!
            by Bill Wilson
            Being younger than 65, with no qualifying health conditions, I don't anticipate getting a vaccine for some time. My wife works for the school district, so she may be eligible in the next phase. President Biden says that supply will be sufficient for all US adults by end of May. I'm hoping that proves...
            Yesterday, 04:16 PM
          • MidMich324
            Reply to What do you think?
            by MidMich324
            Will a shop vac work for the table saw?.
            Yesterday, 11:26 AM