Announcement

Collapse
No announcement yet.

scheppach deco flex problem

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • scheppach deco flex problem

    have had this saw for awhile with no problems,, today i turned i went to use it ,and it has a bad tapping noise coming from inside the casing near the tension adjuster,and when i saw it seems to labour and sounds strange and vibrates like made, any ideas on what has happened,,,, it is oiled regularly,
    thanks

  • #2
    Maybe the counter weight came loose on the motor shaft. That happened to me on my old delta. All of the set screws were loose and threw the whole saw out of balance.
    Locktite and lithium grease on all the joints and it still runs like a charme.
    Rolf
    RBI G4 26 Hawk, EX 16 with Pegas clamps, Nova 1624 DVR XP
    Philosophy "I don't know that I can't, therefore I can"
    Proud Member of the Long Island Woodworkers Club
    And the Long Island Scrollsaw Association

    Comment


    • #3
      thanks Rolf checked that, seems to be in the tension adjuster area,in side the casing,

      Comment


      • #4
        fixed was tension spring,,, whew,

        Comment

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse

        • Sandy Oaks
          Teach - Learn
          by Sandy Oaks
          A modified Sue Mey pattern to fit 1" x 4" x 10" Hard Maple. Cut on the Pegas scroll saw using a Pegas #5 MGT blade. One side says "TEACH". Flip it over and the other side says "LEARN". After sanding, dipped in diluted Shellac, sanded again and another dipping. Comments...
          You do not have permission to view this gallery.
          This gallery has 2 photos.
          Today, 12:13 PM
        • Sandy Oaks
          Reply to First Project - Stretching Cat
          by Sandy Oaks
          Very well done, especially for your first. I too like the added detail.
          Today, 11:22 AM
        • Rolf
          Reply to Insertion of a marquetry pattern in a stained glass window
          by Rolf
          The end result is beautiful I really like that Hummingbird design....
          Today, 09:54 AM
        • Rolf
          Reply to Help with spray adhesive
          by Rolf
          I have used all sorts of methods for putting on patterns. The only time I put a pattern directly on the wood is on Intarsia as the shaping process removes it. I only use blue tape under the pattern on very small projects.

          I Use clear removable contact paper (shelf liner) on the wood and...
          Today, 09:51 AM
        • Rolf
          Reply to Sanding and calibration disk.
          by Rolf
          I agree about how it was advertised, but it is my own fault, I know better. Just for curiosity I may strip the paint off and see how true the plate is.

          The good thing is that while I had my saw blade off I cleaned it sprayed Crud cutter on it let it sit then wiped it off with a skotchbright...
          Today, 09:42 AM
        Working...
        X