Announcement

Collapse
No announcement yet.

Got a Question

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Got a Question

    Are the blade clamps on the Excalibur 21 the same as those of the 788?
    The upper arm and clamp look the same but I don't know bolt hole measurements.
    If they are the same it would be good to know.
    May the wind at you back .....
    Not be from Lunch.

    Don't take life too seriously; No one gets out alive.

    Beauty is in the eye of the BEERHOLDER

    Visit My Gallery

    Oily's Gallery

    http://www.picturetrail.com/oily11

  • #2
    Short answer is...YES!
    "Still Montana Mike"

    "Don't worry about old age--it doesn't last that long."
    Mike's Wood-n-Things LLC

    Comment


    • #3
      Originally posted by wood-n-things View Post
      Short answer is...YES!
      Thanks Mike, Next time try and keep it short.
      May the wind at you back .....
      Not be from Lunch.

      Don't take life too seriously; No one gets out alive.

      Beauty is in the eye of the BEERHOLDER

      Visit My Gallery

      Oily's Gallery

      http://www.picturetrail.com/oily11

      Comment


      • #4
        K..........................
        "Still Montana Mike"

        "Don't worry about old age--it doesn't last that long."
        Mike's Wood-n-Things LLC

        Comment

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse

        • NC Scroller
          Reply to Work in Progress. What is with FOX publishing?
          by NC Scroller
          I often resize just to fit the size of the wood I have on hand. I agree this is a no win situation because of the various software, hardware differences plus the skill level of us, the end users. Even providing the patterns in a digitized format will no fix this because of the reasons I already mentioned....
          Today, 09:52 AM
        • Rolf
          Reply to Work in Progress. What is with FOX publishing?
          by Rolf
          John your original post is a valid question. It is a simple thing to put in the original scale assuming that it was on the original drawing. As a minimum the size of the material required can be stated, although that has been a confusion for folks that have built the clock projects. I field a lot of...
          Today, 09:22 AM
        • Quartz43
          Reply to Work in Progress. What is with FOX publishing?
          by Quartz43
          Maybe nothing has changed ? But is there anything that can be done to make it easier. The very large projects are difficult to copy over several pages and put together properly. I believe in making improvements and not preserving the status quo.

          I enjoy the challenge of cutting a project...
          Yesterday, 08:48 PM
        • keystonecop
          Reply to Work in Progress. What is with FOX publishing?
          by keystonecop
          This is not a problem with the magazine for my issue.. It is a problem with the book having resized the drawings without giving the actual size.

          I do again apologize for my post.. I cannot use the right words to explain it.. so maybe someone should just remove the post....
          Yesterday, 07:29 PM
        • markdavd
          Reply to Work in Progress. What is with FOX publishing?
          by markdavd
          Reading these replies, I am still trying to figure out what the problem really is. I haven't noticed changes in how they publish recently and I don't think I ever had trouble making copies of of the patterns I want to cut.

          How did you copy the patterns 10 years ago? What has changed?...
          Yesterday, 06:43 PM
        Working...
        X