Announcement

Collapse
No announcement yet.

mitch

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • mitch

    I have in mind to buy a Delta 40-560II. Anyone out there that would tell me their experience with this scroll saw? Close work w/3/4" basswood/pine? Blade changing? Vibration? Thanks from a newbie to site.

  • #2
    Welcome A Board!! You will be hard pressed to find a friendlier or more knowledgeable group on the net re: woodworking. Share your knowledge and do not hesitate to ask questions. The only dumb question is the one that remains unasked.

    You may find the stickies at the top of this forum to be very helpful. Use the Link below.

    Message Board FAQ, Suggestions and Feedback - Scroll Saw Woodworking & Crafts Message Board.

    Take a few minutes to read through them. They are chock full of great information.

    Be sure and share pics of your projects. We thrive on pictures. You will find we are not a judgmental group.

    Whatever reason brought you to our forum we are pleased you found us.

    Take some time to read the bylaws of the forum. We do not allow open/direct selling on the forum.
    "Still Montana Mike"

    "Don't worry about old age--it doesn't last that long."
    Mike's Wood-n-Things LLC

    Comment

    Unconfigured Ad Widget

    Collapse

    Latest Topics

    Collapse

    • keystonecop
      Had to post this just for Rolf.
      by keystonecop
      117 puzzles have had their first bath in watco natural oil. My yearly order from the store that buys from me.
      No I do not eat that much mayo....
      You do not have permission to view this gallery.
      This gallery has 1 photos.
      Today, 05:32 PM
    • Rolf
      Excalibur 21 repair #2
      by Rolf
      I just finished rebuilding my friends 2nd EX 21, This one was in much better shape than the first. No rusty bearings this time but I re-greased them anyway.
      I adjusted the front back motion and and the blade is also at 90 degrees to the table when using the locating pin.

      I used...
      Today, 02:44 PM
    • Bill Wilson
      Reply to Recommendations anyone?
      by Bill Wilson
      If it means the difference between cutting something and doing nothing, then go for it. It might not be the choice of most of us, but we aren't working under the same constraints as you. Hope it works out for you. Looking forward to a review, once you get a few miles on it.
      Yesterday, 02:42 PM
    • old fa_t
      Reply to Recommendations anyone?
      by old fa_t
      After totally over-thinking this, I have decided to go ahead with the Micro Mark Saw. It will enable me to do everything I can imagine in my limited space and budget.
      I thank everyone for offering advice, and I look forward to receiving more. As soon as I get it and set it up, I will post pictures...
      Yesterday, 07:37 AM
    • will8989
      Reply to Need any wood?
      by will8989
      Figured it out. The photos were Live and I had to edit them. As you can see, we were quite lucky they didn’t come crashing down in a storm. The last picture was a 2 trunk tree. My son already split a truck load today.

      Next project, the roofer next week. Yippee....
      04-20-2021, 08:56 PM
    Working...
    X