Announcement

Collapse
No announcement yet.

Blade holder for Delta

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Blade holder for Delta


  • #2
    I put that clamp on my Hawk and bought the clamps from
    Pozsgai's Designs - Scroll Saw
    Maybe he can help you.
    Rolf
    RBI G4 26 Hawk, EX 16 with Pegas clamps, Nova 1624 DVR XP
    Philosophy "I don't know that I can't, therefore I can"
    Proud Member of the Long Island Woodworkers Club
    And the Long Island Scrollsaw Association

    Comment


    • #3
      I was looking over the parts diagram for the Delta 40-540 saw and it says that part #40-250 is the Quickset Blade Chuck, which looks like it has been discontinued. Maybe you could try and adapt the part #40-251 Quickset II Blade Chuck instead.
      However, you did say you needed the blade support and I see that what Delta calls the "Blade Support" is actually part #1343632. Apparently it is still available, at least from the place in the link below.

      Delta 40-540 parts breakdown on ToolPartsDirect.com

      It looks like the #40-251 Quickset II Blade Chuck will fit the Delta 40-570 saw as well, but the two parts that Delta calls the "Support" [part #1342241] that the upper blade chuck attaches to and the "Cover" [part #1342242] where the blade tension lever attaches are no longer available. I have been scouring the internet to find these two parts for backups for my own saw as well, but unless someone actually has them squirreled away in drawer somewhere, they are apparently nonexistent.



      Delta 40-570 parts breakdown on ToolPartsDirect.com

      Comment


      • #4
        Tappis, another place to check:
        erplacementparts.com
        Mick, - Delta P-20

        A smile is a small curve that straightens everything out.

        Comment

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse

        Working...
        X