Announcement

Collapse
No announcement yet.

Blade slipping

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Blade slipping

    I have a Makita saw. The blade holders are allen type screws. I just cannot get the blade to stay in. As soon as I turn the saw on there is a little slippage and the tension is gone. I cannot believe I need a torque wrench to to get a blade to stay in. I have used Olsen and flying D blades large and small.

    Maybe a replacement clamps? Sand paper? Corrosive deadly solvent? Trained monkey to keep them tight?

    Thanks

    Brian
    Milwaukee

  • #2
    A routine thing I do with every blade is rough up the ends with some sandpaper. There is a film on them that can cause them to slip out of the clamps. Next thing I would suggest looking at is making sure the allen screws seat perfectly together. Tighten the screws without a blade in them. Look closely at how they meet. If it looks like they aren't making full contact across the entire face of both ends, you may need to file a little off to get them to seat properly. This is all trial & error, so take it slow and work up to it, or it will be like sawing legs off of a table to get it level.
    Homer : "Oh, and how is education supposed to make me feel smarter. Besides, every time I learn something new, it pushes some old stuff out of my brain."

    Comment

    Unconfigured Ad Widget

    Collapse

    Latest Topics

    Collapse

    Working...
    X