Announcement

Collapse
No announcement yet.

cut down blades

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • cut down blades

    the saw i bought s/h came with some cheap blades that were too deep to cut sharp turns, while i am waiting for my new blades to turn up, i took about 3mm of the back of these blades on the bench grinder, not ideal i know, but i'm inpatient and it worked better than i expected, and allowed me to get practicing.

  • #2
    good for you on the McGiver technique.
    Pacifism is great, as long as everyone is participating.



    StephenD


    The Southern Arizona Woodturners Association
    Desert Woodcrafters
    Grandpa for the 7 most amazing children.

    Comment

    Unconfigured Ad Widget

    Collapse

    Latest Topics

    Collapse

    • Gary beasley
      Reply to What do you think?
      by Gary beasley
      I tried a house vac once for a dust collector. It was prone to clogging the lines and when I tried to put a cyclone can on it the vacuum collapsed the garbage can.
      Yesterday, 09:29 PM
    • Gary beasley
      Reply to Vases
      by Gary beasley
      I found this pattern in Steves catalog and freehanded a vase form. This one may appeal to the folks that bought the butterfly vase.
      ...
      Yesterday, 09:25 PM
    • Trackman
      Reply to Vases
      by Trackman
      Sorry took so long to answer. The brown vase I added butterfly instead of doing wood burning. Wanted to keep them so they would appeal to several people. I sold all of them to a flower shop....
      Yesterday, 05:13 PM
    • Bill Wilson
      Reply to My lucky day!
      by Bill Wilson
      Being younger than 65, with no qualifying health conditions, I don't anticipate getting a vaccine for some time. My wife works for the school district, so she may be eligible in the next phase. President Biden says that supply will be sufficient for all US adults by end of May. I'm hoping that proves...
      Yesterday, 04:16 PM
    • MidMich324
      Reply to What do you think?
      by MidMich324
      Will a shop vac work for the table saw?.
      Yesterday, 11:26 AM
    Working...
    X