If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hi, I bought a used delta 40-601 last night for my son. This afternoon he had it going at low speed and was playing with the blower hose plugging it with his finger and the machine shut off and will not start. Any suggestions?
Couple things to try. #1 check to see if the unit has a circuit breaker or fuse that popped. #2 Assuming you have access to an air compressor trying blowing the switch out. There might be a heavy coat of dust in the switch. #3 check the power cord for breaks or a bad connection. #4 check the brushes on the motor.
Got to hospital at 5 and office didn’t open until 5:30. Could have slept to 4 instead of 3. Right knee replacement. Surgery was at 7, he was awake and up by 10:30, pt and out the door by 12. Not much to do today except take meds, and walk 10 minutes an hour. His knee has to bend back to 120 deg. Due...
A modified Sue Mey pattern to fit 1" x 4" x 10" Hard Maple. Cut on the Pegas scroll saw using a Pegas #5 MGT blade. One side says "TEACH". Flip it over and the other side says "LEARN". After sanding, dipped in diluted Shellac, sanded again and another dipping. Comments...
You do not have permission to view this gallery.
This gallery has 2 photos.
Comment