I have a 1985/87 delta 18"scroll saw 40-601 with a burnt pc board in control panel. Was told by delta part is no longer made. Any suggestions on how to save the saw?
Announcement
Collapse
No announcement yet.
need help with a delta scroll saw control panel
Collapse
X
-
Can you still identify the component part numbers? Is it a single side board or multilayer board? I have have rebuilt them in the past (never a saw controller) with hard wire and replacing the burned components. Is it variable speed ? I wonder if a newer speed controller can be addapted? Do you have a schematic?
Sorry my Mr Fix it mode kicked in.
In reallity I would toss the saw and Buy a new one, I dont have time to fix anything anymore.Rolf
RBI G4 26 Hawk, EX 16 with Pegas clamps, Nova 1624 DVR XP
Philosophy "I don't know that I can't, therefore I can"
Proud Member of the Long Island Woodworkers Club
And the Long Island Scrollsaw Association
Comment
Unconfigured Ad Widget
Collapse
Latest Topics
Collapse
-
Reply to New Toy!by RolfQuartz I only bought the air filter, That same model is sold by many distributors, I see Grizzly has it and several others. I was going to build one but this thing works great. I will get a charcoal filter for it also. Great when doing Pyrography. They also had a Pfingst brand flex shaft tool I haven't...
-
Channel: Tools and Blades
Today, 07:50 AM -
-
by will8989Carole, only you would cut sprinkles on a scrollsaw. I would probably use rice and stain it. I just gave up replacing my insert. Its worn, but works for what I need. I do sand it to make sure there are no burrs sticking up to scratch the wood. I will be trying the new contact paper when mine runs...
-
Channel: Tools and Blades
Yesterday, 08:16 PM -
-
Reply to Shawl pinsby will8989Thick hair would need a larger opening, thinner hair would require a smaller opening to stay in place. The one being shown in the utube would probably work for thicker hair. They look way better than a pencil or dowel! That elephant sure is cute in her hair!.
-
Channel: General Scroll Saw
Yesterday, 08:09 PM -
Comment