No announcement yet.

23" Craftsman Scroll Saw For Sale

  • Filter
  • Time
  • Show
Clear All
new posts

  • 23" Craftsman Scroll Saw For Sale

    I have a saw that I inherited a couple years ago and have never used. The following specs apply:

    Heavy cast iron base, table & yoke
    TEFC direct drive, 1/6 HP, 2 speed (1725 & 825 SPM) motor.
    23" throat capacity
    2-5/8" thickness cutting capacity
    20-1/2 x 10" adjustable table, w/insert and angle indicator (0-45 degrees)
    Eye shield
    Built-in dust blower
    Blade tension control

    I doubt the saw has been used for 2 hours, its just like new and everything works perfectly. I'm willing to accept any reasonable offer + shipping (if reqiired). I live in the Tampa Florida area. I hope someone can put this saw to work.

    Anyone interested can reach me directly at [email protected].


  • #2
    If it doesn't sell, donate it to your local Boys and Girls Club and offer to give lessons. Nothing like teaching new scrollers!

    There's a fine line between woodworking and insanity, I'm just not sure which side of the line I'm on!


    • #3
      Not a bad saw if it has veriable speed and does it accept pinless and pinned blades. I have a craftsman and wish I could afford another but one like he is speaking of sells $279 at sears .


      Unconfigured Ad Widget


      Latest Topics


      • Rolf
        Reply to Blades and Square Blocks
        by Rolf
        The first thing you need to Check is that the upper arm is parallel to the table! Check your manual on how to set up your saw. From the specifications the max cut depth is 2.05 inches so you are at the saw limit. I like the Pegas MGT series. The MGt 5 (11.5 TPI) or the 7 (10.4 TPI)...
        Today, 08:57 AM
      • Dan A
        Blades and Square Blocks
        by Dan A
        I don't have much doubt that I asked these questions to Denny in an email back when I got my Pegas saw from him. But none of my saved emails were transferred over from the old computer to this new one.

        Since what I use mostly is 3/4-inch pine and 1/4 inch multiply which pegas blade would...
        Today, 06:33 AM
      • cwmagee
        Reply to Another Celtic cross
        by cwmagee
        Alex, your creativity is amazing, keep up the great work.
        Yesterday, 09:47 PM
      • Harry
        Reply to Toy jeeps
        by Harry
        Hi Jim.

        The paints I used are mainly aerosol spray.

        The green is Rus-oleum Painters touch, craft enamel.

        The red is a stores brand own name, just called Wilko's

        Don't know if you will get either of these in Mexico, but I'm

        sure you...
        Yesterday, 01:18 PM
      • jim_mex
        Reply to Toy jeeps
        by jim_mex
        Great work and patience needed to pull off these smaller toys. You did a fantastic job! I really like them.

        I'm curious to know what type of paints you use if you don't mind sharing the brand name.
        Yesterday, 10:15 AM