No announcement yet.

Need mounting dimensions for DW788

  • Filter
  • Time
  • Show
Clear All
new posts

  • Need mounting dimensions for DW788

    I am designing a stand for the DW788, however mine is in storage 85 miles away. I need to know the measurements for the mounting holes. The distance between centers of the two front holes and the distance to the single back mounting hole. If some has these measurements or can take time to measure your DW788 please Email them to me at [email protected].

    Thank you for your help. Roger

  • #2
    There are 3 mounting holes, 2 in the front and 1 in the back in the center. Between the 2 front holes is 9" center to center. Now if you take a straight line between the 2 holes for the front and find center it is 22 1/2" to the back hole which is slotted for a small degree of variable. Hope that helps.
    John T.


    • #3

      Thank you John T. That is the dimensions I needed. Will post a photo when I am finished. Roger.


      Unconfigured Ad Widget


      Latest Topics


      • Tom in Ashland
        Fiona Kingdon pattern from Summer issue
        by Tom in Ashland
        Quarter inch BB with Red Gum (Australian Eucalyptus) veneer. My first attempt at veneering and there are a couple spots where there was not quit enough glue so small pieces of the veneer came off....
        Today, 07:59 PM
      • millwab
        Cutting Styles
        by millwab
        In preparation for a scrolling demonstration I decided to make up a piece that would show the different ways I've cut puzzles. It's 2 layers of 1/8" BB. The puzzles were cut out as tray puzzles and then glued back in so pieces wouldn't get lost as it was handled.
        Today, 04:41 PM
      • jim_mex
        Reply to Workshop extension and major facelift - a work in progress - update at 13 April
        by jim_mex
        Update at 13 AprilIts been almost a month since my last post and my shop extension is progressing albeit slowly largely due to me nibbling at it on a regular basis rather than sticking with it and going full blast to get it finished.

        The outside
        of the extension is almost finished apart...
        Today, 03:45 PM
      • Rolf
        Reply to New Toy!
        by Rolf
        Quartz I only bought the air filter, That same model is sold by many distributors, I see Grizzly has it and several others. I was going to build one but this thing works great. I will get a charcoal filter for it also. Great when doing Pyrography. They also had a Pfingst brand flex shaft tool I haven't...
        Today, 07:50 AM
      • NC Scroller
        Reply to New Toy!
        by NC Scroller
        Nice score!
        Today, 06:16 AM