Announcement

Collapse
No announcement yet.

jgr last supper

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    jgr last supper

    This is my latest work. I chose to not put a frame , what do you think?
    Tags: None
  • #2
    Another incredible work of art from a master!!

    You are amazing!

    Nancy in AZ
    A clean house is a sign of a broken scroll saw!

    Comment

    • #3
      Great Job on a great pattern. I have never seen that one before.
      Rolf
      RBI G4 26 Hawk, EX 16 with Pegas clamps, Nova 1624 DVR XP
      Philosophy "I don't know that I can't, therefore I can"
      Proud Member of the Long Island Woodworkers Club
      And the Long Island Scrollsaw Association

      Comment

      • #4
        What if you gled it to a backer board and then jus framed the backer board,
        maybe even a matt between the the image and the frame about an inch away from the image..
        I really like and enjoy your work

        Comment

        Previous template Next

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse
        • handibunny
          Reply to EX dust collection holes screwed up a project.!
          by handibunny
          Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
          Today, 09:21 AM
        • Bill Wilson
          Reply to EX dust collection holes screwed up a project.!
          by Bill Wilson
          I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
          Today, 09:06 AM
        • cwmagee
          Reply to EX dust collection holes screwed up a project.!
          by cwmagee
          Carole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
          Today, 08:40 AM
        • Rolf
          Reply to EX dust collection holes screwed up a project.!
          by Rolf
          That is an interesting point Carole. I have done some bevel cutting on the EX and can't say that I have experienced an increase in vibration or any problems with following the lines. I know when I cut one of your bowl designs on my Hawk I really had to concentrate on not pushing down hill....
          Today, 07:28 AM
        • handibunny
          Reply to EX dust collection holes screwed up a project.!
          by handibunny
          Just a word of caution about the size of the blade hole. When I used a DeWalt years ago in the infamous community woodshop, and also with my more recent experiences with the Jet, if you do much bevel cutting at a steep angle, you will cut into the table. That's why inserts have the slot that can be...
          Today, 06:21 AM
        View All
        Working...
        X