If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Are ther any new intarsia challenges in the works? I've hesitated to try in the past. I've done a couple of projects now and think it would be fun to try.
As we speak we got on on the FB group "Intarsia Nuts" a challenge going on....
It's a fairy on a crystal ball....so...join the group and take part.....Hope to see you there.
Here, I will start off the new challenge. Let's make it a 1 of a kind custom project.
I work with a guy who recently restores a 1961 Panel Van. He asked me to duplicate it with an intarsia project. It took awhile to get the pattern the way I needed it, but this is the final result.
Got to hospital at 5 and office didn’t open until 5:30. Could have slept to 4 instead of 3. Right knee replacement. Surgery was at 7, he was awake and up by 10:30, pt and out the door by 12. Not much to do today except take meds, and walk 10 minutes an hour. His knee has to bend back to 120 deg. Due...
A modified Sue Mey pattern to fit 1" x 4" x 10" Hard Maple. Cut on the Pegas scroll saw using a Pegas #5 MGT blade. One side says "TEACH". Flip it over and the other side says "LEARN". After sanding, dipped in diluted Shellac, sanded again and another dipping. Comments...
You do not have permission to view this gallery.
This gallery has 2 photos.
Comment