If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
What is the last issue of the Scroll Saw Woodworking magazine to have come out, the last one I got was the spring issue #46?
I ask because I had trouble getting that one!
#47 (Summer 2012) has been out for quite a while, and #48 (Fall 2012) is imminent. I've heard rumors of it being seen in the wild, but I haven't seen it myself.
--Rob
Last edited by Arcy; 07-02-2012, 09:39 PM.
Reason: speling iz hard
I have the Ornament and Secret Santa Exchange up and ready for everyone that what’s to join this year you have until nov. to sign up this year thank you all that joins up this year
Thanks for the info Denny. When I cut acrylic I always use a skip tooth blade at a slower speed. I just did not realize that the epoxy would cut the same way as acrylic so I followed the materials list in the article.
George
OK folks, picture. I finally figured out how to upload a picture. Here is one each of my version of the oak and cherry boxes. Note the axle peg holding the top in place but allowing it to move.
George
You do not have permission to view this gallery.
This gallery has 1 photos.
OK folks, picture....I finally figured out how to upload a picture. Here are a few of the autumn leaves I cut against the beautiful blue sky we had this morning.
George
You do not have permission to view this gallery.
This gallery has 1 photos.
Tweet
Comment