Announcement

Collapse
No announcement yet.

You probably already know

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • You probably already know

    Before you toss a foam brush strip it. The plastic stiffener makes a great glue spreader, fuzzy chaser etc plus a piece of dowel.
    Cheaper than foam brushes. Foam packing material. You can make your own brushes. They also make great glue daubers for fretwork. You can get glue on every part of the piece without getting much if any glue in the holes.
    Attached Files
    May the wind at you back .....
    Not be from Lunch.

    Don't take life too seriously; No one gets out alive.

    Beauty is in the eye of the BEERHOLDER

    Visit My Gallery

    Oily's Gallery

    http://www.picturetrail.com/oily11

  • #2
    Thanks for the tip.
    Tony

    Comment


    • #3
      Now thats down right clever !
      thanks!
      My very best !
      Carl
      "Home Of The Dust Free Scroll Saw"
      Remember (IT is WHAT it IS)( Unless YOU change IT!)

      Comment


      • #4
        Thanks for another great money saving tip!
        Tammy

        Pressure makes diamonds

        Comment

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse

        • hotshot
          Reply to Darkening oak
          by hotshot
          I've had very good luck using the oven. The wood does soften, but with oak, that usually isn't a problem. It also darkens all the way through.

          He is a flash from the past where I show some puzzle boxes made with oven darkened oak.

          https://forum.scrollsawer.com/forum/...2-...
          Today, 12:32 AM
        • Misouri Wayne
          Reply to Spiral Blades - Tips & Tricks?
          by Misouri Wayne
          Thanks for the post. I have tried spirals in the past and had lots of issues. I need to set down one day and keep cutting with them until I get the hang of it. Part of my problem may have been covered by your number 7. Tried pine thinking it would be easy to cut but now realize the grain may have...
          Yesterday, 07:05 PM
        • Sandy Oaks
          Reply to Eagle
          by Sandy Oaks
          I agree, a beautiful piece and wonderful cutting. Years ago, my father had Alzheimer. The last six months we had him in the VA center in St. Cloud MN. His wood work shop is still in MN. I could not take it down to TN....
          Yesterday, 12:00 PM
        • Rolf
          Reply to Spiral Blades - Tips & Tricks?
          by Rolf
          I have been using spiral a lot more lately Thanks to Charles Hand stunning designs. I have used them of and on since I started scrolling.
          They were a real challenge on my Old Delta SS350. cutting straight in and out was easy, trying to cut details going sideways was the problem because of the...
          Yesterday, 09:16 AM
        • Jimern
          Reply to Spiral Blades - Tips & Tricks?
          by Jimern
          The best tip I have with spirals is to cut straight lines backwards. instead of pushing the work piece into the blade, pull it toward you. Seems to allow for better control on straight lines (most other lines too)
          Yesterday, 05:27 AM
        Working...
        X