Announcement

Collapse
No announcement yet.

hockey player pattern

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    hockey player pattern

    Hello  Does anyone have a hockey player pattern.
    I need to make some Christmas tree ornaments.
    Thanks Mick
    Tags: None
  • #2
    Re: hockey player pattern

    HEy Michael

    I hope that you get this. I found one for you. Fo to Www.wildwooddesigns.com Then do a search for pattern number 1512. This is the only one that I have come upon recently. I will check back in my books to see if there might be another one about.

    Good Luck

    BIG DEL

    Comment

    • #3
      Re: hockey player pattern

       Thanks  Big Del
       I ordered the pattern last week.
        Mick

      Comment

      Previous template Next

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse
      • Rolf
        Reply to EX dust collection holes screwed up a project.!
        by Rolf
        I just did a quick job on my table. Charles Hand has noticed that the adhesive on the new rolls of Contact brand shelf paper leaves a residue. He has changed to The duck brand. I just bought a roll and covered my table with it. It is a tough slick surface. It will be interesting to see how it holds...
        Today, 04:44 PM
      • axor
        Reply to Shawl pins
        by axor

        Yes, they can be used for hair. If they are made a little larger than the original, the shawl pins will work great in the hair!...
        Today, 03:21 PM
      • handibunny
        Reply to EX dust collection holes screwed up a project.!
        by handibunny
        Rolf, smaller bowl-cutting angles, 30˚ or less, usually don't present a problem either with vibration or for cutting into the table. It's when you get into the 40˚ and 45˚ range that things get dicey for both. (The Seyco saw doesn't even cut bevels greater than 35˚ or so!) If you add even a slight...
        Today, 09:21 AM
      • Bill Wilson
        Reply to EX dust collection holes screwed up a project.!
        by Bill Wilson
        I've done some bevel cutting on my EX-21 as well and also have not experienced any added vibration, nor have I cut into the table. Perhaps I haven't cut at a steep enough angle, but the existing blade hole has been sufficient. I do despise the useless vacuum holes, but I've learned to live with them...
        Today, 09:06 AM
      • cwmagee
        Reply to EX dust collection holes screwed up a project.!
        by cwmagee
        Carole Your hole size was a concern when I purchased the Pegas Replacement Table for my EX21, because I had cut into the side of hole on the original table, The damage I did to the old table was due to the blade adjustments were not in the center of blade holders. So far that has not been an issue...
        Today, 08:40 AM
      View All
      Working...
      X