Announcement

Collapse
No announcement yet.

compound patterns

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • betsypup
    Guest started a topic compound patterns

    compound patterns

    I am new to scroll sawing and have found my passion!!! I just got Sam Keener's book '128 compound scroll saw patterns' from the library and have made my first 3D figure, a sail boat on one side and a dolphin on the other. I am fascinated by these '2-in-1' designs. Can anyone tell me other books that have these designs, or if Keener has written any more books???
    Thanks, Betsypup

Unconfigured Ad Widget

Collapse

Latest Topics

Collapse

  • Eugene Downes
    1930 Ford AA
    by Eugene Downes
    Sometimes a person just can't find a good pattern to cut a picture so they have to just make their own. Thats me setting on the running board, the picture was taken about 1973 just before I retired from the Military 1974. After I retred I drove that truck from Pensacola, Florida to Salida, Colorado...
    Today, 04:56 PM
  • Eugene Downes
    Stack Cutting
    by Eugene Downes
    Like most of you out there I like to stack cut because I can finish more than 1 at a time. I've tried many ways in the past to hold everything together. I've used screws, hammer and nails, staples and clamps. The best and easyest way I have found is to use a brad gun. It leaves a very small hole and...
    Today, 03:20 PM
  • Eugene Downes
    Scroll saw blade holders
    by Eugene Downes
    I built these many years ago using scrap 1 inch and 2x4. Drilled as many holes as needed for tjhe different sized blades I used. It has always worked great for me and I don't have any trouble finding the blades....
    Today, 03:05 PM
  • Eugene Downes
    Dremel hand drill
    by Eugene Downes
    I really like this set up because it is ready to use at my work bench or at my scroll saw....
    Today, 02:54 PM
  • will8989
    Reply to Scrollsaws
    by will8989
    Search for a used hegner. Parts are readily available and their service Dept is top notch. My first one was a craftsman and hubby bolted it to the workbench it was on. Then I switched to a bandsaw than my Hegner 21 years ago....
    Today, 12:33 PM
Working...
X