Announcement

Collapse
No announcement yet.

corner shelve

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • corner shelve

    shelf is made from marine ply 3/8 it is 13 wide 24 high and 12 deep door opens on pin hinges and the ginger bread is waste from a angle wing that i make also send pic of them later This friends is my first pattern that i made
    Attached Files

  • #2
    Nice work - and an ingenious use of scrap for the gingerbread..
    Ian

    Scrolling with a Dewalt 788

    Comment


    • #3
      Very nice first, Froggie. Well done and functional.
      Mike

      Making sawdust with a Dremel 1680.
      www.picturetrail.com/naturephotos

      Comment


      • #4
        Nice shelf Frog, I like it!

        Chris
        What! There's no coffee?!!

        Comment

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse

        • will8989
          Rolf,
          by will8989
          Are you ok Rolf?
          Today, 05:43 PM
        • Jim McDonald
          Reply to About ornament exchange
          by Jim McDonald
          Dave, I will participate. Thanks for doing this again.
          Today, 09:10 AM
        • Rolf
          Reply to Testing this blower motor
          by Rolf
          Without the complete schematic it is hard to know what is correct.
          That said, it is a multispeed blower that obviously has a controller board. That board varies the power to the motor. By doing what you did you bypassed that. You put power across the low and high windings. If any thing connecting...
          Today, 07:43 AM
        • evilbadger
          Reply to Testing this blower motor
          by evilbadger
          If he connected to red and black and the motor spun wouldn't that indicate the motor is grounded? Without connecting the white the circuit isn't complete and the motor should not spin.
          Today, 06:40 AM
        • cwmagee
          Reply to Testing this blower motor
          by cwmagee
          The reason for the smoke is incorrect wiring, posible melted insulation between motor windings and motor frame.

          You mentioned connecting power to the red & and black wire. Did you do anything with White wire? Per the lable on the motor the black wire is high the Red is low. White common...
          Yesterday, 08:41 PM
        Working...
        X
        😀
        🥰
        🤢
        😎
        😡
        👍
        👎