If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
JT,
They are in the works. The goal is to get the actual Websites for WCI and SSW launched, then we are going to focus on the message boards. We are still working out some software bugs, but it's going to be soon, I promise!!!
I have both types of saw A tilting table Hawk g426 and an Older Excalibur with a tilting head. Unlike Carole for bevel cuts I prefer the tilting head I do larger projects and it is easier for me.
Regarding compound cuts they are cut at 90 degrees.
If you have a good saw, and can set the table accurately, you should be good to go. Give a holler if you need help. ๐
Randy, I swapped out the clamps on the Jet for the Pegas clamps as soon as they became available. I found the Jet clamps just too fidgety for my taste.
Comment