If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have seen a lot of post about the Delta SS350. I have this saw and have been thinking of selling it. Should I keep this saw? I am a beginner and have never used it.
I kept mine as a backup for my RBI Hawk. I think it is as good an entry level saw as any out there if not better. The clamps are great. I would use it until you decide what direction the hobby takes you.
Rolf
RBI G4 26 Hawk, EX 16 with Pegas clamps, Nova 1624 DVR XP
Philosophy "I don't know that I can't, therefore I can"
Proud Member of the Long Island Woodworkers Club
And the Long Island Scrollsaw Association
I have three of these saws they are real easy to use and mantaine I recelent bought a dewalt 788 but havent had time to use it have read and heard they are a good saw that is my 2 cents good luck
The Hegner like some other saws have a sweet spot or not so sweet spot where they may vibrate. I know they need to have a solid footing.
When we were younger (2005) we used to bring our saws to our club meeting in an old barn with wooden floors. The seasoned scrollers all had Hegners. The rest...
I assume you are talking about changing the stroke length. Looking at the manual it says you can shorten it for cutting thin wood and or metal. I have never known anyone that did that. We have several Hegner owners in our club. I am not one of them.
Has anyone replaced the eccentric on the Hegner scroll saw or made any adjustments to this part.
I bought an used Hegner m22 and it vibrates at about 3/4 speed. Maybe I'm just over thinking this problem, last year I purchased a multi cut 3/25 inch Hegner it is a single speed and it runs like a...
Comment