Good evening everyone! I didn't have much time in the shop, but I did cut a few different woods with my #5 reverse penguin silver blade. I left the saw tilted at 20 degrees like it was for the aspen. I didn't get pictures of the blade coming up, but it seemed like it was coming all the way up, but I will check again on that.
All pictures are of the bottom of the cut
The first one is a little over 1/2" redwood
Redwood2.jpg
This one is 1/2" willow
Willow.jpg
The last one is almost 3/4" oak
Oak.jpg
I know the first 2 are pretty fibrous woods. But the oak was a bit of a surprise. I would like to have tried some of my other blades ie ultra reverse, skip tooth reverse, just didn't have time. I did want to post my findings tonight and see if you thought these were normal. Thanks again for all your opinions!!
All pictures are of the bottom of the cut
The first one is a little over 1/2" redwood
Redwood2.jpg
This one is 1/2" willow
Willow.jpg
The last one is almost 3/4" oak
Oak.jpg
I know the first 2 are pretty fibrous woods. But the oak was a bit of a surprise. I would like to have tried some of my other blades ie ultra reverse, skip tooth reverse, just didn't have time. I did want to post my findings tonight and see if you thought these were normal. Thanks again for all your opinions!!
Comment