Announcement

Collapse
No announcement yet.

light box

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • light box

    Well last weekend I made a light box out of a cardboard box. It sure made a difference in the quality of my pictures that I put on my website. I need to work on my lighting now. I hung a flood light from my ceiling fan and used two different desk lamps on the sides. One was a LED light and the other was a reg 100 w light bulb. So my question is is there any special light that would be better an the other? Thanks in advance for your suggestions.

  • #2
    I don't have any suggestions about the lighting but I do have a suggestion for you to share some of your pics and your website with the curious.
    "Still Montana Mike"

    "Don't worry about old age--it doesn't last that long."
    Mike's Wood-n-Things LLC

    Comment


    • #3
      light box

      Wood N Things I don't have my website up yet just starting out. Here is a couple of things I made. You will be able to tell which one I used a light box on.
      Attached Files

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • Bill Wilson
        Reply to Tough Decisions
        by Bill Wilson
        Well, unfortunately, I have also decided to let my subscription lapse. I've been debating it for the past couple years. It isn't so much the money, but it's more the disappointment when yet another issue has so little in it that really appeals to me. The final straw was this past Fall/Winter edition...
        Today, 09:51 AM
      • planeur
        Reply to My covid angel
        by planeur
        Thanks to all !😀 Your comment are very good and make sense!

        My piece is 8"X8" X 1/2" thick.
        I though when I cutted the piece to do it in 1 piece or 4/5 , but after a while I decided to do it in one piece and carved it to have a 3D aspect.
        Was it a good idea.....?...
        Today, 09:45 AM
      • Rolf
        Reply to My covid angel
        by Rolf
        Great designe! I would have gone a bit further than Linda, Scott and Gladefade I would cut it into more pieces to make shaping easier. Taper the clouds from right to left, taper the wings so that they are lower where they attach to the body. Taper the neck so that it looks like it is going into the...
        Today, 09:02 AM
      • Rolf
        Reply to Tough Decisions
        by Rolf
        The never ending dilemma. I only get two magazines SSWWC and Wood carving Illustrated. Even if I don't make something in every issue there is usually something in each one that I have never tried and that will either challenge or inspire me. Yes I know that I do test cutting for them and they have occasionally...
        Today, 08:49 AM
      • NC Scroller
        Reply to My covid angel
        by NC Scroller
        I would start by tracing your piece on a piece of 1/8" (3mm) material and then cut the back our such that it is a fraction smaller that your project. Then I would cut your piece into two pieces. I mean cut the angel from the cloud. I would then put the cloud on the 1.8" backer and then with...
        Today, 07:27 AM
      Working...
      X