If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Nice work Daryl185... and a big "Congrats" on the sales!
"Orphans are easier to ignore before you know their names. They're easier to ignore before you see their faces. It's easier to pretend they're not real before you hold them in your arms. But once you do, everything changes."
http://marleb.com
DW788. -Have fun in the shop or it isn't a hobby anymore. NOTE: No trees were killed in the sending of this message, but a large number of electrons were terribly inconvenienced.
Right now I live in the greater Houston area, which is by Texas standards 'next door', meaning you only have to drive 4 hours, 2 of them being the Houston commute. But yea, I miss the old missions. That's why I made this project.
I have both types of saw A tilting table Hawk g426 and an Older Excalibur with a tilting head. Unlike Carole for bevel cuts I prefer the tilting head I do larger projects and it is easier for me.
Regarding compound cuts they are cut at 90 degrees.
If you have a good saw, and can set the table accurately, you should be good to go. Give a holler if you need help. 😁
Randy, I swapped out the clamps on the Jet for the Pegas clamps as soon as they became available. I found the Jet clamps just too fidgety for my taste.
Comment