Announcement

Collapse
No announcement yet.

Pattern revision

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • BobD
    replied
    I have the same problem!!! If I'm cutting a portrait with a spiral blade, I'm fine, but those antique-style patterns are just too much!

    Bob

    Leave a comment:


  • Castle
    replied
    Pattern revision

    THANKS..... I can split a line with half on each side of the blade but a all black pattern plays tricks on these old eyes. Monte

    Leave a comment:


  • BobD
    replied
    Monte,
    Here's the link. http://www.scrollsawer.com/inthisissue.php
    Sorry we didn't get it up before hand!

    Best Regards,
    Bob Duncan
    SSW&C
    Last edited by BobD; 07-05-2006, 09:15 AM.

    Leave a comment:


  • Castle
    started a topic Pattern revision

    Pattern revision

    In the Fall issue it had a little notice about the black pattern of the pic frame in issue #23. It said a revised pattern is on the website. WHERE???? Monte

Unconfigured Ad Widget

Collapse

Latest Topics

Collapse

  • Jo Labre
    Reply to Joining the new tool frenzy
    by Jo Labre
    I cut a bunch of chakte viga and leopardwood pieces for the Viking project and the blade seems pretty good yet. I imagine if I were to only cut softer hardwoods (?) the blade would last quite a long time. Still - $25.00 is a lot more than the cost of standard scroll saw blades....
    Today, 02:36 PM
  • old fa_t
    Reply to Old,,,,but new here
    by old fa_t
    The room was supposed to be storage but it's my office? now with a roll top desk and a barristers bookcase.which I built when I was able.
    Today, 01:55 PM
  • Rolf
    Reply to Joining the new tool frenzy
    by Rolf
    Very nice! I really like your setup especially for the dust collection. I would have to figure out a way to re-weld the blade.
    And Oh to have wall space and organizational skills!
    Today, 09:55 AM
  • Rolf
    Reply to Old,,,,but new here
    by Rolf
    Welcome! As the others have said, lots of support and knowledge here ready to be shared.
    Is the 6 x10 your workspace or your entire apartment. ?
    Today, 09:34 AM
  • Rolf
    Reply to Log slice ornaments
    by Rolf
    Most of the cut outs were done with the scroll saw.
    Karl I have a couple of power carvers. The classic Dremel with a flex shaft I then bought a Ram Power carver, they both use 1/8 shank bits. I have a bunch of carbide cutters from when our Printed circuit board facility at work was dismantled....
    Today, 09:29 AM
Working...
X