Announcement

Collapse
No announcement yet.

New Updated Website

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • New Updated Website

    I have updated and am continuing to update my website. I will have pictures of some of the great work I saw and sawed (ha ha) at the the PA picnic soon. Take a look http://www.justscrollinthroughmilford.com
    ]

  • #2
    That's a website well worth visiting. Thanks for showing it to us .

    Gill
    There is no opinion, however absurd, which men will not readily embrace as soon as they can be brought to the conviction that it is readily adopted.
    (Schopenhauer, Die Kunst Recht zu Behalten)

    Comment


    • #3
      Very nice work and site thanks for sharing

      Charlie,
      Charlie
      "Everything Happens for a Reason"
      Craftsman 18in. 21609

      http://wolfmooncreations.weebly.com

      Comment


      • #4
        Congratulations on your site, I just discovered it...

        Congratulations on your site, I just discovered it and
        enjoyed very much reading it.

        Pedro.
        http://www.finescrollsaw.com

        Comment

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse

        • Bill Wilson
          Reply to Tough Decisions
          by Bill Wilson
          Well, unfortunately, I have also decided to let my subscription lapse. I've been debating it for the past couple years. It isn't so much the money, but it's more the disappointment when yet another issue has so little in it that really appeals to me. The final straw was this past Fall/Winter edition...
          Today, 09:51 AM
        • planeur
          Reply to My covid angel
          by planeur
          Thanks to all !😀 Your comment are very good and make sense!

          My piece is 8"X8" X 1/2" thick.
          I though when I cutted the piece to do it in 1 piece or 4/5 , but after a while I decided to do it in one piece and carved it to have a 3D aspect.
          Was it a good idea.....?...
          Today, 09:45 AM
        • Rolf
          Reply to My covid angel
          by Rolf
          Great designe! I would have gone a bit further than Linda, Scott and Gladefade I would cut it into more pieces to make shaping easier. Taper the clouds from right to left, taper the wings so that they are lower where they attach to the body. Taper the neck so that it looks like it is going into the...
          Today, 09:02 AM
        • Rolf
          Reply to Tough Decisions
          by Rolf
          The never ending dilemma. I only get two magazines SSWWC and Wood carving Illustrated. Even if I don't make something in every issue there is usually something in each one that I have never tried and that will either challenge or inspire me. Yes I know that I do test cutting for them and they have occasionally...
          Today, 08:49 AM
        • NC Scroller
          Reply to My covid angel
          by NC Scroller
          I would start by tracing your piece on a piece of 1/8" (3mm) material and then cut the back our such that it is a fraction smaller that your project. Then I would cut your piece into two pieces. I mean cut the angel from the cloud. I would then put the cloud on the 1.8" backer and then with...
          Today, 07:27 AM
        Working...
        X