Announcement

Collapse
No announcement yet.

photos

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • photos

    Can some one message me on how to post Photo on this site I know how to on another site just like this so here go's

    Derek
    DeWalt 788

  • #2
    Derek,

    You' the nerd He he.

    Guess it works here too as your picture of Piglet Hall is showing fine, and looking fine I might add.

    Regards,
    Marcel
    http://marleb.com
    DW788. -Have fun in the shop or it isn't a hobby anymore.

    NOTE: No trees were killed in the sending of this message, but a large number of electrons were terribly inconvenienced.

    Comment


    • #3
      Looks good here on my end too Derek.

      What type of wood did you use?
      Bill

      DeWalt 788



      aut viam inveniam aut faciam

      God gives us only what we can handle.. Apparently God thinks I am one tough cookie.....

      Comment


      • #4
        Originally posted by ozarkhillbilly
        Looks good here on my end too Derek.

        What type of wood did you use?
        Not sure what wood but very hard came off an old table top !

        Derek
        DeWalt 788

        Comment

        Unconfigured Ad Widget

        Collapse

        Latest Topics

        Collapse

        • planeur
          Reply to Cutting guide for straight cut on a scroolsaw
          by planeur
          Merci Rolf , I use Pegas blade but not that kind, interesting what they say about it.
          I will try them.
          Have a good day

          planeur
          Today, 09:22 AM
        • will8989
          Reply to My beauties
          by will8989
          Looks like glass with the sun shining through it....
          Today, 08:08 AM
        • will8989
          Reply to My beauties
          by will8989
          He puts biscuts between the long pieces, is that what you meant? He has stainless screws in the lips then puts the plugs on top of that. Scott, cutting one doesn’t take long. It’s the removing of the tiny drill hole, spraying each piece with distilled water, letting dry, sanding and sometimes flap...
          Yesterday, 10:55 AM
        • Rolf
          Reply to Cutting guide for straight cut on a scroolsaw
          by Rolf
          Like Bob said clamp a straight edge to the table and adjust it to compensate for the blade drift. There are some blades that have no or very little drift. Like the Olson PGT series it also seems to me that the Pegas MGT 3 or larger cut very straight....
          Yesterday, 07:54 AM
        • Rolf
          Reply to My beauties
          by Rolf
          I now you do beautiful work but I have to say your attention to details on these baskets is impressive. soft smooth edges, no visible glue squeeze out. And of course the cutting boards are beautiful. I am guessing that Bruce cut a spline in the end of the board and then dowels. I have not seen that...
          Yesterday, 07:49 AM
        Working...
        X