Announcement

Collapse
No announcement yet.

Melamine

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Melamine

    Has anyone ever tried cutting melamine? That is the very light plastic that they use to make things such as plates, cups etc. I think I've found a place that I can purchase sheets of it. If you have, what size / type of blade is best, also best way to drill starter holes without cracking the stuff?

    Thanks
    Bigfoot
    Tags: None
    Previous template Next

    Unconfigured Ad Widget

    Collapse

    Latest Topics

    Collapse
    • will8989
      Rolf,
      by will8989
      Are you ok Rolf?
      Today, 05:43 PM
    • Jim McDonald
      Reply to About ornament exchange
      by Jim McDonald
      Dave, I will participate. Thanks for doing this again.
      Today, 09:10 AM
    • Rolf
      Reply to Testing this blower motor
      by Rolf
      Without the complete schematic it is hard to know what is correct.
      That said, it is a multispeed blower that obviously has a controller board. That board varies the power to the motor. By doing what you did you bypassed that. You put power across the low and high windings. If any thing connecting...
      Today, 07:43 AM
    • evilbadger
      Reply to Testing this blower motor
      by evilbadger
      If he connected to red and black and the motor spun wouldn't that indicate the motor is grounded? Without connecting the white the circuit isn't complete and the motor should not spin.
      Today, 06:40 AM
    • cwmagee
      Reply to Testing this blower motor
      by cwmagee
      The reason for the smoke is incorrect wiring, posible melted insulation between motor windings and motor frame.

      You mentioned connecting power to the red & and black wire. Did you do anything with White wire? Per the lable on the motor the black wire is high the Red is low. White common...
      Yesterday, 08:41 PM
    View All
    Working...
    X
    😀
    🥰
    🤢
    😎
    😡
    👍
    👎