Announcement

Collapse
No announcement yet.

Looking for a pattern

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Looking for a pattern

    I am looking for a pattern that was made by John Nelson and published in Scroll Saw Work Shop in one of the past few issues. It is a cross. It has another cross and crown in the middle of it. Any help would be appreciated.

    Thanks,
    Joe

  • #2
    Here is John Nelson's site http://www.scrollsawcentral.com/
    John T.

    Comment


    • #3
      Looking for a pattern

      Thanks John. I'll contact him about the cross.

      Joe

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • Rolf
        Reply to Blades and Square Blocks
        by Rolf
        The first thing you need to Check is that the upper arm is parallel to the table! Check your manual on how to set up your saw. From the specifications the max cut depth is 2.05 inches so you are at the saw limit. I like the Pegas MGT series. The MGt 5 (11.5 TPI) or the 7 (10.4 TPI)...
        Today, 08:57 AM
      • Dan A
        Blades and Square Blocks
        by Dan A
        I don't have much doubt that I asked these questions to Denny in an email back when I got my Pegas saw from him. But none of my saved emails were transferred over from the old computer to this new one.

        Since what I use mostly is 3/4-inch pine and 1/4 inch multiply which pegas blade would...
        Today, 06:33 AM
      • cwmagee
        Reply to Another Celtic cross
        by cwmagee
        Alex, your creativity is amazing, keep up the great work.
        Yesterday, 09:47 PM
      • Harry
        Reply to Toy jeeps
        by Harry
        Hi Jim.

        The paints I used are mainly aerosol spray.

        The green is Rus-oleum Painters touch, craft enamel.

        The red is a stores brand own name, just called Wilko's

        Don't know if you will get either of these in Mexico, but I'm

        sure you...
        Yesterday, 01:18 PM
      • jim_mex
        Reply to Toy jeeps
        by jim_mex
        Great work and patience needed to pull off these smaller toys. You did a fantastic job! I really like them.

        I'm curious to know what type of paints you use if you don't mind sharing the brand name.
        Yesterday, 10:15 AM
      Working...
      X