If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I'm doing a series of puzzles for the grandkids. For the younger tikes I need to find a source for the little red pegs that the commercial puzzles have to help the littlest fingers. Any help appreciated.
"It is so cute" - it is the first what I hear when I show this project. I haven’t done 3D patterns for a long time (about a year), it’s quite difficult and takes a long time. But I don’t regret the time I spent on this new pattern - Christmas deer, I think it turned out great. It is...
Making of 3D scroll saw project - Christmas deer. Pattern is available at PDF and vector formats, so you can use it for srollsawing, lasercutting or CNC. Pat...
I've been using the bags from Amazon and a heat gun my wife bought when she was a preschool teacher. Unless you are wrapping of small parts, you don't need a sealer. Just fold it over and hold it with a small piece of scotch tape on the back. After you shrink it it's sealed enough to keep everything...
My process is a bit different. Since I am using heat shrink bags when you seal the open end you trap a lot of air in them. When you start to heat the bag to shrink it you create a large bubble. I continue to heat the bag until it does pop a hole. I have been doing this for years. The shrink wrap...
Tweet
Comment