Announcement

Collapse
No announcement yet.

Searching for Heartland Creations

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Searching for Heartland Creations

    Does anyone know what happened to Heartland Creations?

    I am looking to replace a pattern I purchased from Heartland Creations sometime ago but can't find any suppliers and the website is gone too.

    Toni
    Canadian Woodcrafters

  • #2
    Don't know if this will help but at this link you can find a few "Heartland Creations" patterns.

    http://www.woodcrafters.on.ca/us/scroll2.shtml

    The link to those patterns will be on the left
    Mike P.

    He is a man of sense who does not grieve for what he has not, but rejoices in what he has.
    - Epictetus

    Comment


    • #3
      Thanks for the link. Unfortuantely I don't think Bob at Woodcrafters Emporium has updated his site in a long time. I used to order from him but now he seems difficult to reach and last I heard he was moving more toward cabinetry and millwork.

      Comment

      Unconfigured Ad Widget

      Collapse

      Latest Topics

      Collapse

      • hotshot
        Reply to Darkening oak
        by hotshot
        I've had very good luck using the oven. The wood does soften, but with oak, that usually isn't a problem. It also darkens all the way through.

        He is a flash from the past where I show some puzzle boxes made with oven darkened oak.

        https://forum.scrollsawer.com/forum/...2-...
        Today, 12:32 AM
      • Misouri Wayne
        Reply to Spiral Blades - Tips & Tricks?
        by Misouri Wayne
        Thanks for the post. I have tried spirals in the past and had lots of issues. I need to set down one day and keep cutting with them until I get the hang of it. Part of my problem may have been covered by your number 7. Tried pine thinking it would be easy to cut but now realize the grain may have...
        Yesterday, 07:05 PM
      • Sandy Oaks
        Reply to Eagle
        by Sandy Oaks
        I agree, a beautiful piece and wonderful cutting. Years ago, my father had Alzheimer. The last six months we had him in the VA center in St. Cloud MN. His wood work shop is still in MN. I could not take it down to TN....
        Yesterday, 12:00 PM
      • Rolf
        Reply to Spiral Blades - Tips & Tricks?
        by Rolf
        I have been using spiral a lot more lately Thanks to Charles Hand stunning designs. I have used them of and on since I started scrolling.
        They were a real challenge on my Old Delta SS350. cutting straight in and out was easy, trying to cut details going sideways was the problem because of the...
        Yesterday, 09:16 AM
      • Jimern
        Reply to Spiral Blades - Tips & Tricks?
        by Jimern
        The best tip I have with spirals is to cut straight lines backwards. instead of pushing the work piece into the blade, pull it toward you. Seems to allow for better control on straight lines (most other lines too)
        Yesterday, 05:27 AM
      Working...
      X