Announcement

Collapse
No announcement yet.

Serenity Prayer

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Serenity Prayer

    Here is another design from Sheila Landry. I cut out 11 total.
    IMG_0904 3.jpg

    Attached Files
    Keith

  • #2
    Beautiful, I have always liked that plaque and maybe one day I will get brave enough to try it. I still cringe at doing even a few letters - and that's a whole lot of 'em! Thanks for sharing.
    Melanie from East TN

    Comment


    • #3
      Very nicely done.. I too like the wisdom of that little prayer.
      AKA Paul from Washington State

      Comment


      • #4
        Wow , love it fine job !
        Usually busier than a cat in a sandbox !!!!!!!!!!! MB { Dewalt 788 only }

        Comment


        • #5
          Well done.
          Rolf
          RBI G4 Hawk, Delta SS350, Nova 1624 DVR XP
          Philosophy "I don't know that I can't, therefore I can"
          Proud Member of the Long Island Woodworkers Club
          And the Long Island Scrollsaw Association

          Comment


          • #6
            Nicely done Keith. Looks like you've been busy. How many shows are you planning on this year?
            Homer : "Oh, and how is education supposed to make me feel smarter. Besides, every time I learn something new, it pushes some old stuff out of my brain."

            Comment


            • #7
              I have five scheduled but would like to do more. With my wife's mom being so sick though, I don't know if that is possible.
              Keith

              Comment

              Unconfigured Ad Widget

              Collapse

              Latest Topics

              Collapse

              • NC Scroller
                Reply to Local craft fair very disappointing.
                NC Scroller
                Sad but seeing this trend more and more. I think there are several reasons. In general fewer people are interested in hand crafted goods made by local artists. They see what they like and buy it no matter if I was hand crafted locally or commercially produced. Second the made overseas stuff is cheaper...
                Today, 07:43 AM
              • WynnD
                Reply to Confused "newbie", here!
                WynnD
                The set screw Carole mentioned is opposite the blade tightening knob. She is correct the screws will make the blade be off center. I had only one problem with the DW. There is a fitting on the end oif the motor arm. Mine came loose and made a racket. I followed the video you mentioned and it was very...
                Today, 06:40 AM
              • handibunny
                Reply to Confused "newbie", here!
                handibunny
                Start by retracting the set screw fully on both upper and lower clamps, then turn them each the same amount until they have protruded enough to grab the blade when you tighten the thumb screw. If for some reason the blade is still not completely perpendicular, adjust them until it is. Should not be...
                Today, 06:08 AM
              • will8989
                Reply to Local craft fair very disappointing.
                will8989
                A lot of fairs in this area are going back to the way it used to be meaning you need to submit pictures of your work and some equipment. A lot of promoters are also visiting craft shows and talking to vendors and asking them to apply for their show. this is my 3rd year at the howard county 3 day show...
                Today, 12:12 AM
              • cwmagee
                Reply to Confused "newbie", here!
                cwmagee
                If my memory is correct you have a set screw on the left side of blade clamp and the thumb screw on the right side on both upper and lower blade clamps. If you do not adjust both set screws so they are the same (just proud of blade clamp slot), your blade will not be square.
                Yesterday, 10:01 PM
              Working...
              X