If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I just finished this piece for a friend that works with the GSP rescue. It was cut out of 3/4" ash. If I did this right you can see the picture. All comments are welcome.
I have 2 female GSD, one is 11 years old and one is 6.
Got both as gifts, and love them.
Surprisingly, my neighbors love them too, they are both well behaved and do not bark for no reason.
To my wife they are big expressive babies, to me they are big expressive dogs.
I'm the Alpha male, and they obey me (more than my wife) and they truly love us unconditionally.
They are very intelligent, sometimes stubborn (passive resistance), very protective and scare the hell out of anyone walking on the sidewalk on the other side of the chain link fence (especially if they haven't seen her lying there first LOL) by just barking.
Where is your pattern from? if it's yours would you consider making it available to us?
Regards,
Marcel
http://marleb.com
DW788. -Have fun in the shop or it isn't a hobby anymore. NOTE: No trees were killed in the sending of this message, but a large number of electrons were terribly inconvenienced.
Scott you teased me on this one...I thought you stated GSP as in German Shorthaired Pointers (I have two)...none the less very nice work, I'm sure your friend will enjoy it very much.
I haven't posted in a few months but I have been keeping up. I agree with what Mark is saying. To make everything for everyone would be very difficult. And I understand (from my wife's perspective) that computer apps are totally made for nerds - in her opinion. The breakdown is often between two of...
Yes I'm still using the one I built I did some upgrades to it though. I swapped out the pipes for linear motion rails and made the gantry out of aluminum. I guess if I were to upgrade now I would be looking for a full size machine that could do 4x8 sheets of plywood with an automatic tool changer but...
With all these new tool stories, I was working on and old one. About 9 years ago, I built a router table. Then, before it was finished, I had to start using it. And I have used it over the years. A couple of months ago, While I was contemplating cleaning, I looked at the machine and decided to finish...
Comment